Description
QIZHI Micro Hydro Water Turbine Generator
Specifications:
-Power: 500W
-Flow: 0.007m3/s
-Head: 6-15m
-Speed: 500-1500r/min
-INS.CL: E
-Current: 2.3A
-Phase: 1 phase
Procedure:
√After the unit foundation be poured with concrete is solidified, the unit is installed in place and then watered in sequence.
√The water level must be measured with a level gauge to ensure that the unit is fixed in a horizontal position.
√The gap between the unit and the floor should be sealed with cement, and no water seepage is allowed.
√After the unit is installed, check again and turn the turbine shaft of the turbine by hand. If the machine is flexible, the installation is finished.
√Installation requirements: The bottom plane of the turbine in close contact with the foundation plane.
NOTE:
500w hydro generator only can be used with the following two conditions:.
1) The vertical Water level difference between the unit foundation and the hydro generator must be in this range:7-15M.
2) The water flow must can fully fill the water tube that is above 7.5cm diameter all the time.
Kevin T. Mabie –
The plate on the generator is in Chinese with no english. Could use english instructions.