Description
Y&H 1000W Grid Tie Inverter Power Limiter DC25-60V Solar Input AC110V/240V Auto Switch
Y&H 1000W Grid Tie Inverter Power Limiter DC 25-60V Solar Input AC
Specifications
- Type: 110V/240V Auto recognition
- Rated Power (Peak/Continuous): 1000W / 900W
- DC Input Voltage: 22V~65V
- AC Output Frequency Range: 46Hz~65Hz
- Peak Inverter Efficiency: 90%
- Night Power Consumption: 0.5W
- Mppt efficiency: 99%
- Anit-Island Protection: yes
- Storage Temperature Range: -40°F~ 149°F
- Size:41*28*15.5cm(16.14″*11″*6.1″)
- Package include:
- 1XGrid Tie Inverter limiter
- 1 x Power Cord(us)
- 1 x English User’s Manual
- 1 x Limiter clamp with sensor & 2m cable
Start DIY your solar system. Reduce your electricity bill.
Why do you need a grid tie inverter with limiter?
Because in some countries, Power Meters (the one provided by the electricity provider in the area) are not aware of the direction of power flow. the consumers will be charged for power even if it is given to the grid.
Now!!! We call this limiter. It delivers only the power needed by the load and prevents delivering excess power hence avoids excess power in going back to the Grid.
Applied Standards: VDE-AR-N 4105:2018-11;DIN VDE V 0124-100:2020-06
- The 22-65V model inverter will start up at 26V, after starting, the inverter can work in 22V-60V .Solar Panel Voc cannot be higher than 60V.
- Vmp 30v-48v Solar panels connected in Parallel suggested, for example : 4 pcs 200-250w (Vmp 31v solar panels in parallel ).
- Vmp = solar panel working voltage; Voc = solar panel open circuit voltage. So don’t think that 60V is the working voltage (Vmp)
- Please be noted, This grid tie inverter cannot be used as off grid/stand alone solar system. The output need to be connected to the grid power. Can not supply power directly to the AC loads.
- DO NOT use solar controller load ports to connect to the inverter
- Only use the 36V/48V battery to power the inverter
- Use a battery to power the inverter, please use a circuit breaker.
- The limiter wiring does not exceed 66 feet.
DIY Solar System
DC Input
AC output
Stackable Connection
MPPT technology
Creative MPPT tech makes efficiency higher than 99%. Peak conversion 80%. Consider the conversion rate of solar panel is about 80%, for example, if you need 500W power output from the inverter, you need to connect it to a solar panel that 500 / 0.8 / 0.8 equals about 780W, (780w * 0.8 * 0.8 = 500w)
Multiple protections
Low power consumption, over current protection, over temperature protection, reverse polarity protection, etc.
Fan Cooling
The fan is controlled by temperature and power, it will start intelligently. Increase the life of the inverter. Of course, it is recommended to install the inverter in a ventilated, cool and dry place.
Customer Questions & Answers
Q: Does the current limiter have current limit?
A: The current below 4.5A will make the current limiter less sensitive. It is recommended to use it at 4.5-9A.
Q: Does the buckle of the current limiter require wires?
A: It is recommended to use the correct diameter restrictor wire. If the wire is too thin, please loop the wire inside the current limiter buckle to reach the proper size of the buckle. If the wire is too thick, the current limiter buckle cannot be buckled, and the current limiter will not work.
Q: Why does the grid-tie inverter not work or stop after working for a while?
A: When the power of the load in the working state is too low, the grid-tie inverter will not be able to recognize the load, so the inverter cannot be started. After starting the grid-tie inverter, if the power of the working load is lower than 100w, the inverter may stop working.
We recommend that when using 1000w grid tie inverter, ensure that the load power in the working state is not less than 100w
Scott Gress –
If you are a DIY type, there are a great device at a low cost. Also arrived fast. I have two of them–one on each 120V leg. Altho the instructions discourage setting them up in parallel with a single farm of panels, it actually works pretty darn well.
almelmissing –
Excellent customer service. Really responsive. Helped with problem solving. My unit died on me after a few months of usage. They were great at getting back to me. After all problem solving tips and suggestions failed they offered me a new unit or a full refund.
Andre –
So far it works well, I’m very satisfied. It’s much better than those $100 inverters without limiter. The build quality is good. My only concern is that it’s running a bit hot at or above 500watts, around 56*C based on the screen thermometer. I’m considering buying a second unit for the other leg, but wanted to see if this one will last through the California summer, since overheating is generally not a good thing for electronics.
Ompong48 –
Off grid solar power
MATTEO –
Have been using 1000w grid tie inverter for 6 months now. I’ve had to oil the fan bearings once but everything else has been working great. Im running on 120 volts ac. I tried it at 240 but with the limiter clamp only on one leg it didn’t work that well.