220V/500W Micro Hydro Water Turbine Generator, Hydroelectric Generator Full Copper Core Single Phase Generator for Household (Color Green)
Micro Hydro Water Turbine Generator Specification:
Output voltage: AC 220V
Nozzle diameter: 1.8CM
Water level difference: 7-15M
Flow rate: 0.008-0.011m3/s
Pressure tube diameter: 8CM (3 inches)
Material: copper + metal
1x micro hydro generator
Micro Hydro Water Turbine Generator Installation steps:
After the unit foundation of the poured concrete is solidified, the unit is installed in place and then watered sequentially. The water level must be measured with a water level gauge to ensure that the unit is held in a horizontal position. The gap between the equipment and the floor should be sealed with cement and no water seepage is allowed. After installing the equipment, check and turn the turbine shaft of the turbine by hand. If the machine is flexible, the installation is complete.
Installation requirements: The bottom of the turbine is in close contact with the base plane.
The 500w hydroelectric generator can only be used under the following two conditions:
The vertical water level difference between the unit base and the hydro-generator must be within the following range: 5-15M
The water flow must always be filled with water pipes larger than 7.5cm in diameter.